四氯合钴(Ⅱ)-4-氯苄基吡啶季铵盐的制备及其晶体结构和抗菌性能

合成了1种含四氯合钴配阴离子的4-氯苄基吡啶季铵盐[4-ClBzPy]2[CoCl4];利用元素分析仪、X射线单晶衍射仪以及紫外光谱仪和红外光谱仪等分析了其组成、晶体结构及光谱学性质;利用电导仪测定了[4-ClBzPy]2[CoCl4]的电导,并检测了其对金黄色葡萄球菌和大肠杆菌的抗菌活性.结果表明,合成的[4-ClBzPy]2[CoCl4]季铵盐为单斜晶系,P2(1)/c空间群,晶胞参数为a=0.769 5(13)nm,b=1.895 1(3)nm,c=0.946 3(15)nm,β=93.183(2)°,V=1.378 0(4)nm3,Z=2,Dc=1.470g/cm3,GOOF=1.007,R1=0.041 8,wR2=0.100 2.与此同时,季铵盐[4-ClBzPy]2[CoCl4]对金黄色葡萄球菌和大肠杆菌均具有较好的抗菌活性.     

铁-金橙G-共振散射光谱法测定水中痕量Fe3+

研究了Fe3+-金橙G(OG)体系的共振光散射光谱,发现Fe3+对OG的共振光散射有增强效应。进一步研究发现,其增强值(△I)与加入Fe3+的质量浓度呈线性关系,对条件进行了优化,并建立了一种测定Fe3+的新方法,方法的线性范围为0.028～1.00μg/mL,检出限为0.009μg/mL,用于水样中痕量Fe3+的测定,结果满意。     

修饰铂电极-示波双电位滴定法测定Zn(Ⅱ)

制备了锌修饰铂电极,建立了一种新的测定Zn(Ⅱ)的示波双电位滴定法。在六次甲基四胺溶液(1.0mol/L)中(pH=5.5),用制备的修饰铂电极作为双指示电极,以EDTA标准溶液滴定Zn(Ⅱ),利用示波器屏幕上荧光点的显著最大位移指示滴定终点。在3.0×10-4～2.0×10-3mol/L的浓度范围内,Zn(Ⅱ)的回收率为99.9%～100.2%。该修饰电极具有良好的稳定性和重现性,对Zn(Ⅱ,1.0×10-3mol/L)溶液连续11次测定,所得终点电位值均在10.1mV左右,其相对标准偏差(RSD)为0.5%。用来测定含锌的实际样品,其结果与指示剂法测定的值基本一致。     

An effective and rapid determination by MALDI/TOF/TOF of methionine sulphoxide content of ApoA‐I in type 2 diabetic patients

Increased oxidation of low density lipoprotein (LDL) is characteristic of atherosclerosis. In this frame, high density lipoproteins (HDL) play an important role, being able to remove lipid peroxides (LPOs) and cholesterol from oxidized LDL, so exhibiting a protective role against atherosclerosis. A wide range of reactive compounds lead to the oxidation of methionine (Met) residues with the formation of methionine sulphoxide (MetO) in apolipoprotein A‐I (ApoA‐I). Consequently, the determination of MetO level can give both an evaluation of oxidative stress and the reduced capability of ApoA‐I in LPOs and cholesterol transport. For these reasons, the development of analytical methods able to determine the MetO level is surely of interest, and we report here the results obtained by MALDI mass spectrometry. Copyright © 2013 John Wiley & Sons, Ltd.     

Structural investigations of anthranilimide derivatives by CoMFA and CoMSIA 3D-QSAR studies reveal novel insight into their structures toward glycogen phosphorylase inhibition

In the present work, three-dimensional quantitative structure–activity relationship (3-D QSAR) studies on a set of 70 anthranilimide compounds has been performed using docking-based as well as substructure-based molecular alignments. This resulted in the selection of more statistically relevant substructure-based alignment for further studies. Further, molecular models with good predictive power were derived using CoMFA (r ^2?=?0.997; Q ^2?=?0.578) and CoMSIA (r ^2?=?0.976; Q ^2?=?0.506), for predicting the biological activity of new compounds. The so-developed contour plots identified several key features of the compounds explaining wide activity ranges. Based on the information derived from the CoMFA contour maps, novel leads were proposed which showed better predicted activity with respect to the already reported systems. Thus, the present study not only offers a highly significant predictive QSAR model for anthranilimide derivatives as glycogen phosphorylase (GP) inhibitors which can eventually assist and complement the rational drug-design attempts, but also proposes a highly predictive pharmacophore model as a guide for further development of selective and more potent GP inhibitors as anti-diabetic agents.     

Validated LC‐MS method for simultaneous quantitation of catalpol and harpagide in rat plasma: application to a comparative pharmacokinetic study in normal and diabetic rats after oral administration of Zeng‐Ye‐Decoction

A simple and efficient liquid chromatography‐mass spectrometry (LC‐MS) method was developed and validated for simultaneous quantitation of catalpol and harpagide in normal and diabetic rat plasma. Protein precipitation extraction with acetonitrile was carried out using salidroside as the internal standard (IS). The LC separation was performed on an Elite C₁₈ column (150 × 4.6 mm, 5 µm) with the mobile phase consisting of acetonitrile and water within a runtime of 12.0 min. The analytes were detected without endogenous interference in the selected ion monitoring mode with positive electrospray ionization. Calibration curves offered satisfactory linearity (r > 0.99) at linear range of 0.05–50.0 µg/mL for catalpol and 0.025–5.0 µg/mL for harpagide with the lower limits of quantitation of 0.05 and 0.025 µg/mL, respectively. Intra‐ and inter‐day precisions (RSD) were <9.4%, and accuracy (RE) was in the ?6.6 to 4.9% range. The extraction efficiencies of catalpol, harpagide and IS were all >76.5% and the matrix effects of the analytes ranged from 86.5 to 106.0%. The method was successfully applied to the pharmacokinetic study of catalpol and harpagide after oral administration of Zeng‐Ye‐Decoction to normal and diabetic rats, respectively. Copyright © 2013 John Wiley & Sons, Ltd.     

The MAP/PH/N retrial queue in a random environment

We consider the MAP/PH/N retrial queue with a finite number of sources operating in a finite state Markovian random environment. Two different types of multi-dimensional Markov chains are investigated describing the behavior of the system based on state space arrangements. The special features of the two formulations are discussed. The algorithms for calculating the stationary state probabilities are elaborated, based on which the main performance measures are obtained, and numerical examples are presented as well.     

Hydrothermal Synthesis and Crystal Structure of One 3D Coordination Polymer of Nickle （II） Achieved from 5-Iodo-isophthalic Acid Ligand

A new coordination polymer [Ni（L）（m-bix）（H2O）]n （1, H2L = 5-iodo-isophthalic acid, m-bix=1,3-bis（imidazol-1-ylmethyl）-benzene） has been synthesized by the hydrothermal method and characterized by IR, elemental analysis, powder XRD and single-crystal X-ray analysis. The crystal is of triclinic, space group Pī with a = 9.1638（3）, b = 10.2319（3）, c = 13.2463（4） ？, α = 80.1710（10）, β = 83.671（2）, γ = 70.3790（10）o,C22H19NiIN4O5, Mr = 605.02, V = 1150.85（6） ？3, Dc = 1.746 g/cm3, F（000） = 600, μ = 2.225 mm-1, S = 1.045 and Z = 2. The final R = 0.0388 and wR = 0.1257 for 5089 observed reflections with I 〉 2σ（I）. In the title complex, the M and P layers are arranged alternately to give a double-layer structure by the symmetry related hydrogen bonds, and these double-layers are further joined together to achieve a 2D supramolecular architecture through I···π interaction involving iodine atoms and imidazole rings. The thermal stability of the title complex was studied by thermal gravimetric （TG） and differential thermal analysis （DTA）.     

Highly efficient regioselective ring openings of N-tosylaziridines to haloamines using ferric(Ⅲ) halides

FeX3（X = Cl, Br） were found to be very effective reagents and powerful catalysts for regioselective ring openings of a variety of N-tosylaziridines with them to afford the corresponding b-haloamines in good to excellent yields with high regioselectivity under mild conditions. At the same time, 13 new compounds were obtained firstly. Moreover, the b-bromoamine prepared could be transferred into b-nitroamine with NaNO2 in moderate yield.     

Improved device reliability in organic light emitting devices by controlling the etching of indium zinc oxide anode

A controllable etching process for indium zinc oxide （IZO） films was developed by using a weak etchant of oxalic acid with a slow etching ratio. With controllable etching time and temperature, a patterned IZO electrode with smoothed surface morphology and slope edge was achieved. For the practical application in organic light emitting devices （OLEDs）, a sup- pression of the leak current in the current-voltage characteristics of OLEDs was observed. It resulted in a 1.6 times longer half lifetime in the IZO-based OLEDs compared to that using an indium tin oxide （ITO） anode etched by a conventional strong etchant of aqua regia.